Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
[] FAQ
My remote control does not work. What
should I do?
Check the antenna
or cable connection
to the unit.
Check the batteries of the remote control.
Check if there is an obstacle
between
the infrared
sensor window
and the
remote control.
Test the signal output
.If OK, then possible infrared sensor trouble.
(Refer to"lR Signal Check" on page 46.)
Aim the remote control directly
at the infrared sensor window
on the
front of the unit.
Reduce the distance to the unit.
Re-insert the batteries
with their polarities(+/-signs)
as indicated.
When there is an infrared-equipped
device such as PC near this unit, it
may interrupt
the remote control
signal of this unit.
Move the infrared-equipped
device away from this unit, change the
angle of the infrared sensor or turn off the infrared communication
function.
I
How come the Initial setup appears every
• Connect
the RF cable to the unit directly
and run the initial setup.
time I turn on this unit?
• Make sure to complete
the channel
scan before turning
offthe
unit.
• Make sure auto channel
scan has been completed.
(Refer to"Auto
Channel Scan"on page 14.)
• Auto channel
scan must be completed
when you set up the unit for the
first time or move it to a location
where previously
unavailable
channels
are broadcast.
• The selected channel
may not be broadcasting.
Why I cannot watch some of TV programs?
• When auto channel
scan is interrupted
and not completed,
some channels
will not be received. Make sure to complete.
(Refer to"Auto
Channel Scan"on
page 14.)
• The selected channel
cannot
be viewed by the V-chip setting.
(Refer to "V-chip" on page 25.)
• The unit requires some kind of antenna
input. An indoor antenna
(rabbit
ears), an external antenna,
or an RF coaxial cable from your wall or cable
/satellite
box needs to be plugged
into the unit.
How co--e there is no ima-e
from the
. • Check if the right input mode is selected by pressing
[INPUT] or using
u_
y
•
,
,
connected
external
devices7
[¢H.
IV
]. (Refer to 'Switching
Each Input Mode'on
page 15.)
•
• Check the antenna
or cable connection
to the unit.
Whenever
I entered
channel
number,
• Many digital channels
have alternate
channel
numbers.The
unit changes
the numbers
automatically
to the ones signifying
the broadcasting
it changes
automatically,
stations. These are the numbers
used for analog broadcasts.
I
• Clean the disc.
• Ensure the disc is correctly
inserted.
M
disc c not
"e
la ed bac"
• Check if the disc is defective
by trying another
disc.
y
a n
D p y
,.
•Canceltheparentallockorchangethecontrollevel.
Is there any way I can play my disc?
• Insert a correct
disc that plays back on this unit.
• Handle a disc with special care so that it does not have fingerprints,
scratches or dusts on its surface.
• Captions
that are delayed a few seconds behind the actual dialogue
are
Why are captions
not displayed
entirely?
common
for live broadcasts.
Most captioning
production
companies
can
Or, captions
are delayed
behind the
display a dialogue
to maximum
of 220 words per minute.
Ifa dialogue
dialogue,
exceeds that rate, selective editing
is used to insure that the captions
remain up-to date with the current TV screen dialogue.
How can I set the clock ?
• There is no clock function
on this unit.
ii ii_iiii
iiiii_ii!
i! _,'ii_i:
_i i !'i_,_:
EN
Publicidad
Tabla de contenido
