Before Use; Fitting/Changing The Saw Blade; Turning The Appliance Handle; Adjusting The Footplate - Parkside PFS 710 D3 Traducción Del Manual De Instrucciones Original

Before use

Fitting/changing the saw blade

WARNING!
► Always remove the plug from the power
socket before working on the appliance .
Otherwise, there is a risk of injury .
♦ Turn the quick-release chuck
stop and hold it in this position .
♦ Push the required saw blade
quick-release chuck
CAUTION!
► The teeth of the saw blade
downwards!
♦ Let go of the quick-release chuck
returns to its initial position . The saw blade
is now locked .

Turning the appliance handle

RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance . The
handle can be turned by 90° to the right
or left . This allows the ON/OFF switch
be moved to the most suitable position
depending on the working conditions .
♦ Press the release button
handle to the right or left .
♦ Allow the handle
■ 6 │ GB │ IE
as far as the
into the
as far as the stop .
must point
so that it
and turn the
to engage .

Adjusting the footplate

RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance .
♦ Adjust the footplate
depth .
♦ To do so, undo the locking lever
the footplate
♦ Lock this position by closing the locking lever

Stroke rate selection

Use the adjusting wheel
stroke rate ( — = lower stroke rate, + = increased
stroke rate) .
The stroke rate can also be changed during
operation .

Use

Switching on and off

During operation, you can choose between instan-
taneous and continuous operation .
Switching to instantaneous operation
♦ Press the ON/OFF switch
lights up when the ON/OFF switch
pushed in slightly or fully and illuminates the
working area in low light conditions .
to
Switching off instantaneous operation
♦ Release the ON/OFF switch
Switching to continuous operation
♦ Press the ON/OFF switch
position with the locking switch
Switching off continuous operation
♦ Press the ON/OFF switch
again .
according to the cutting
and move
to the corresponding position .
to select the desired
. The work light
.
and lock it in this
.
and release it
PFS 710 D3
.
is