Maintenance; Refrigerant Gas; Spare Parts - Astralpool CDP Serie Manual Tecnico

ASTRALPOOL CDP LINE V2

6. MAINTENANCE

It is strongly recommended a general servicing of the appliance to check the proper operation
of the appliance, maintain its performance, to avoid future faults and preserve the unit in good
conditions.
An updated record of each maintenance procedure should be kept that includes all elements
repaired or substituted.
This operation must be obligatorily performed by a professionally qualified person and always with
the appliance disconnected from the electrical power supply.
This operation should be carried out at least once a year (more frecuently if necessary) and
includes several elements:
•
Cleaning of the filters: See IMAGES 10 (pg. 103)
Wash the filters with warm soapy water, rinse abundantly and dry them. Replace if necessary.
•
Revision of the safety mechanisms.
•
Dusting the circuit board.
•
Checking the electrical connections.
•
Checking gas pressure.
•
Checking fan and frigorific coils: See IMAGES 11 (pg. 110)
•
Checking that condensation drainage is clean.

7. REFRIGERANT GAS

This appliance uses R410-A as frigorific gas. This gas is classified as not dangerous according to
directive 67/548/EEC or 1999/45/EC. It is non-flammable and has no flash point.
R410-A has no chlorine content, so it has a zero Ozone Depletion Potential (ODP), but contains
fluorinated greenhouse gases, covered by the Kyoto Protocol, with a modest Global Warming
Potential (GWP) of 1890.
When in liquid state can cause frostbite due to inmediate evaporation.
Vapour is heavier than air and can cause suffocation.
Don't discharge R410-A gas into the atmosphere, or manipulate the appliance in any way that can
result in the discharge of the frigorific gas.

8. SPARE PARTS

See IMAGES 12 (pg.111) for exploded view of the appliance.
© ASTRALPOOL 2015 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT
.
ENGLISH
Pag: 17