Jacuzzi J-200 Serie Ficha Técnica De Preinstalación página 18

Parts incorporating electrical components, except for
remote control devices, must be located or fixed so
that they cannot fall into the bath.
Parts containing live parts must be inaccessible to a
person in the bath.
If the building's electrical system is not able to guaran-
tee a stabile power supply, it is recommended to install
a voltage stabiliser that suitably dimensioned for the
required power upstream of the equipment.
For connection to the power supply network, we recommend
installing an isolating multi-pole switch (
sure complete disconnection in the event of a category III over-
voltage; these devices must be positioned in an area that com-
plies with the safety regulations
The disconnection devices must be installed in the power sup-
ply network according to the installation instructions.
The installation of electrical devices and equipment (sockets,
switches, etc.) near the spa must be in compliance with legal
standards and regulations in the country where the spa is in-
stalled.
For the equipotential connection as required by specific nation-
al standards, the installer must use the terminal provided (stand-
ard EN 60335.2.60) under the electronic box (
with the symbol . In particular, an equipotential condition must
be established for all metallic masses surrounding the spa, for ex-
ample water and gas pipes, metallic platforms, and so on.
The appliance comes equipped with an LED lighting system, in
compliance with Regulation EN 62471:2009.
CAUTION! Before carrying out any maintenance opera-
tion, disconnect the appliance from the power supply line.
12), which will en-
12), and marked
18