Regulating The Near-End-Of-Paper Sensor; Printing Unit - Olivetti Nettun 7000 Open Guía Rápida

REGULATING THE NEAR-END-OF-PAPER SENSOR

Note
The near end-of-paper sensor is set up in the factory to function correctly for
the most common types of paper roll.
If you notice that when the near end-of-paper condition is notified, there is either too
little or too much paper left, you can adjust the sensor setting.
The setting of the sensor depends on the diameter of the paper roll hub. For a hub of
a given diameter, moving the lever towards the rear of the machine will result in less
paper being present on the hub when notification is given, while moving the lever
towards the front will result in more paper being present. To regulate the near end-of-
paper sensor, proceed as follows.
1. Open the cover of the cash
register by pressing fully
down the release button.
2. If a roll of paper is loaded,
remove it.
3. Move the green adjustment
lever in the direction of the
cash register operator panel
to be notified earlier
(for hubs of larger
diameters).
Move the lever towards
the rear of the main module
to be notified later
(for hubs of smaller
diameters).
4. Load the paper roll.

PRINTING UNIT

The printing unit is composed of a single thermal printer. It comprises of a bay for
holding a paper roll of 80 mm width or, installing the adapter supplied, of 57.5 or 60
mm widths.
10