Regulating The Near End-Of-Paper Sensor; The Printing Unit - Olivetti Nettun 7000 Guía Rápida

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REGULATING THE NEAR END-OF-PAPER SENSOR

Note:
The sensor signalling the near end-of-paper condition is regulated in the
factory to satisfy the requirements of the most widely used types of paper
roll.
However, if you notice that when the near end-of-paper condition is notified, there is
either too little or too much paper left, it is possible to modify how the sensor is
regulated.
Regulation is based on the diameter of the hub of the roll used. For a hub of a given
diameter, moving the lever towards the rear of the machine results in less paper
being left when notification is given, while moving the lever towards the front results
in more paper being left. To regulate the near end-of-paper sensor, proceed as
described below.
1.
Open the printer cover by
pressing the associated
release button.
2.
If a paper roll is present,
remove it.
3.
Move the green adjustment
lever towards the operator
panel to be notified sooner
(in the case of larger
diameter hubs) or towards
the rear of the module to
have later notification (in the
case of smaller diameter
hubs).
4.
Load the paper roll.

THE PRINTING UNIT

The printing unit is composed of a thermal printer with 1 station. The printer bay can
hold a paper roll of 80 mm. Alternatively, rolls of 57.5 / 60 mm can also be used if the
adapter is installed.
The printer is equipped with a cutter that permits tickets to be cut automatically.
The heading can be printed by pressing 0
10
X .

Publicidad

Tabla de contenido
loading

Tabla de contenido