Installation Procedure; Info - Jacuzzi sasha 2.0 Ficha Técnica De Preinstalación

Info

As soon as you receive the product, check that it is in perfect
condition and if not, immediately notify the forwarding agent.

Installation procedure

CAUTION: this equipment may not be installed
outdoors.
Any installation types/methods which differ from those
specified must be assessed on an individual basis and must
comply, without fail, to the indicated provisions.
The following installation types are supported (refer also to the
relevant instructions):
WALL MOUNTED
ref. "a" - with the panel P1 (provided) and the covering panels P
(optional).
The panel P1 closes up the space by the equipment zone , whilst
the panels P are installed on the bare wall of the equipment, be-
hind the front frame (W).
ref. "b/c" - without covering panels P.
The cladding system (plasterboard, etc.) can be installed as indi-
cated:
- resting against the frame (W) (ref.b);
- behind the frame (W) (ref.c).
the size of the area is based on the measurements.
CORNER
ref. "d"/d1 - with the panel P1 (provided) and the covering panels
P (optional).
ATTENTION: the front frame (W), protruding from the
walls of the appliance, ensures a clearance between
the appliance itself and the wall: this is required to
ensure adequate ventilation.Ventilation must always
be provided!
Do not obstruct the ventilation outlet of the Jacuzzi®
sauna covering panel (P) in any way!
Should you wish to install a panel to close off the front
area of the appliance (between the covering frame
and the ceiling), you must ensure adequate ventila-
tion (for the sauna and the hammam), as instructed; in
addition, you must ensure that the entire panel is com-
pletely removable for inspection and/or subsequent
maintenance operations of the hydraulic components
present on the upper limit of the appliance.
Install the appliance to walls without skirting boards
and/or projections.
Where possible, we recommend leaving adequate
space, behind the appliance, in order to facilitate
subsequent inspection and maintenance opera-
tions. This measure also facilitates assembly of the
structure and the various connections.
The installation area must comply with the following character-
istics:
- Optimal room temperature: approximately 22-25 °C
- Room height: min 250 cm
- Walls: straight and level
- Flooring: tiled or laid; in any case, it must be waterproof;
this includes the front area of the appliance.
With the sauna module, the flooring must not be plastic
or carpeted.
NOTE: with models equipped with water jets, we recommend plac-
ing a collection pit at the centre of the installation area (Pr) designed
to deal with water leakages in the event of faults or malfunctioning;
with this aim in mind, the floor must be sloping (see
The supports (feet) of the appliance frame, present across the
entire surface, must always rest completely against the floor, and
subsequently conform to dimensions.
1
Pr
2
Pr
13
1 and 2).