Franklin Electric INLINE CONSTANT PRESSURE SYSTEM El Manual Del Propietario

BEFORE YOU START
BEFORE INSTALLING PUMP, BE SURE TO READ
THIS OWNER'S MANUAL CAREFULLY.
REFER TO PRODUCT DATA PLATE(S) FOR
ADDITIONAL OPERATING INSTRUCTIONS AND
SPECIFICATIONS.
C A U T I O N
Keep work area clean, well-lit and uncluttered.
Keep safety labels clean and in good condition.
Wear safety glasses while installing or performing maintenance
on pump.
Adhere to the guidelines of the National Electric Code (NEC) or
Canadian Electric Code (CEC), and any other state and local
codes for ALL electrical installations. Check with the
appropriate agencies or contact a licensed electrician.
Adhere to the guidelines of national, state, and local plumbing
Hazardous voltage.
codes when installing this product. Check with the appropriate
Can shock, burn, or
agencies or water system professional for additional
cause death.
information.
Ground pump before
Most water system problems result from improper installation.
connecting to power
It is suggested that you read this manual carefully before
supply. Disconnect
installing your pump.
power before working
The "TROUBLESHOOTING SECTION" will assist you in
on pump, motor
locating and eliminating the cause of any trouble you may
or tank.
encounter after installation. Check and make available all the
tools you will need to install your pump. Required tooling may
include wrenches, pipe sealant, pipe fittings and nipples,
screwdriver, etc. Be sure to have available proper and
adequate wiring material to complete the installation correctly.
INLINE CONSTANT
PRESSURE SYSTEM
OWNER'S MANUAL
IMPORTANT INFORMATION FOR INSTALLERS
THIS EQUIPMENT IS INTENDED FOR INSTALLATION BY
TECHNICALLY QUALIFIED PERSONNEL. FAILURE TO INSTALL
IT IN COMPLIANCE WITH NATIONAL AND LOCAL
ELECTRICAL CODES, AND WITHIN FRANKLIN ELECTRIC
RECOMMENDATIONS, MAY RESULT IN ELECTRICAL SHOCK
OR FIRE HAZARD, UNSATISFACTORY PERFORMANCE, AND
EQUIPMENT FAILURE. FRANKLIN INSTALLATION
INFORMATION IS AVAILABLE FROM PUMP MANUFACTURERS
AND DISTRIBUTORS, AND DIRECTLY FROM FRANKLIN
ELECTRIC. CALL FRANKLIN TOLL FREE 800-348-2420 FOR
INFORMATION.
W A R N I N G
SERIOUS OR FATAL ELECTRICAL SHOCK MAY RESULT FROM
FAILURE TO CONNECT THE INLINE SYSTEM, METAL
PLUMBING, AND ALL OTHER METAL NEAR THE INLINE
SYSTEM OR CABLE, TO THE POWER SUPPLY GROUND
TERMINAL USING WIRE NO SMALLER THAN MOTOR CABLE
WIRES. TO REDUCE RISK OF ELECTRICAL SHOCK,
DISCONNECT POWER BEFORE WORKING ON OR AROUND
THE WATER SYSTEM. DO NOT USE INLINE SYSTEM IN
SWIMMING AREAS.
READ AND FOLLOW SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see this
on your pump or in this manual, look for one of the following
signal words and be alert to the potential for personal injury:
D A N G E R warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
W A R N I N G warns about hazards that can cause serious
personal injury, death or major property damage if ignored
Hazardous voltage.
WA R N I N G
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect
power before working
on pump, motor
or tank.
C A U T I O N warns about hazards that will or can cause
minor personal injury or major property damage
.
if ignored
ATTENTION!
OF THIS EQUIPMENT!
WA R N I N G
symbol
.