Group Control - Toshiba MMC-AP0151H Manual De Instalación

7
APPLICABLE CONTROLS
In case of installation to high ceiling
When the height of the ceiling to be installed exceeds
the standard value, adjustment of air volume is
necessary. Set up the high ceiling.
• For the operation procedure, refer to the item "To
incorporate a filter sold separately".
• For the "Setup data" in Procedure
"Installable ceiling height list".
Change of lighting time of filter sign
According to the installation condition, the lighting time
of the filter sign (Notification of filter cleaning) can be
changed.
Follow to the basic operation procedure
1 2 3 4 5
→ → → →
(
• For the item code in Procedure
• For the [Set data] in Procedure
data of filter sign lighting time from the following
table.
Setup data
0000
0001 150H
0002 2500H (At shipment from factory)
0003 5000H
0004 10000H
4
, select in the
6
→
).
3
, specify [01].
4
, select the setup
Filter sign lighting time
None
To secure better effect of heating
When it is difficult to obtain satisfactory heating due to
installation place of the indoor unit or structure of the
room, the detection temperature of heating can be
raised. Also use a circulator, etc. to circulate heat air
near the ceiling.
Follow to the basic operation procedure
1 2 3 4
→ → →
(
• For the item code in Procedure
• For the set data in Procedure
data of shift value of detection temperature to be set
up from the table below.
Setup data
0000
0001
0002
0003
0004
0005
0006

Group control

In a group control, a remote controller can control up
to maximum 8 units.
• For cabling procedure and cables of the individual
line (Identical refrigerant line) system, refer to
"Electric work" in this Manual.
• Cabling between indoor units in a group is performed
in the following procedure.
Connect the indoor units by connecting the remote
controller inter-unit cables from the remote controller
terminal blocks (A, B) of the indoor unit connected
with a remote controller to the remote controller
terminal blocks (A, B) of the other indoor unit.
(No polarity)
• For address setup, refer to the Installation Manual
attached to the outdoor unit.
17
5 6
→ →
).
3
, specify [06].
4
, select the setup
Detection temp shift value
No shift
+1°C
+2°C (At shipment from factory)
+3°C
+4°C
+5°C
+6°C