Maintenance; Manual Cleaning - EdilKamin LAGUNA W 25 Instalación Uso Y Mantenimiento

• Maintenance and inspections carried out to
standard and with regular intervals as well
as only using original spare parts are fun-
damental for correct, problem and anomaly-
free operation, guaranteeing a long boiler
life.
• Maintenance is compulsory and must be
regularly carried out periodically.
• Maintenance and inspections not carried
out can cause damage to property and peo-
ple.
• The inspection is necessary to determine
the actual status of the boiler and compare
it with the original status.
• Maintenance is necessary to bring the
boiler to the original conditions status.
• As a result, maintenance should involve
cleaning, setting or replacing worn parts.
• At the end of each heating season, you
need to inspect the boiler to maintain the
characteristics and effi ciency of the entire
system unchanged.
• After each cleaning procedure, the boiler
must be checked to ensure everything
moved or removed during maintenance is
correctly re-positioned.
• At the end of each season, you are advised
to carry out in-depth cleaning of the boiler
since the mineral ash can be a corrosive
agent and reduce boiler reliability.

MAINTENANCE

MANUAL CLEANING

Boiler cleaning must take place with the boiler
cold, as follows:
• cut electrical current placing the main switch
on the control panel to position 0;
• open the lower door and carefully remove the
catalyser in the combustion chamber by remov-
ing it, moving it forward (Fig. 1);
• clean the wood chamber by removing all the
ash deposited and carefully give the combus-
tion chamber an in-depth clean to remove all
the deposits (Fig. 2);
• put the catalyser back inside the combustion
chamber, paying attention that it is fully resting
and placed at the centre of the chamber;
• remove the upper, rear cover on the boiler
(Fig. 3) (should be carried out by the TSC
- Technical Support Centre authorised by
Edilkamin);
• unscrew the two screws blocking the door
of the smoke container and proceed to clean
inside the smoke box;
• delicately remove the smoke retarder inside
the piping, using a tool if needed to do so;
• use a steel brush supplied to clean the tube
bundle (Fig. 4) (this should be carried out by the
TSC - Technical Support Centre authorised by
Edilkamin);
• clean the mobile shutter of any scale (Fig. 5)
(this should be carried out by the TSC - Techni-
cal Support Centre authorised by Edilkamin).
You are advised to clean the "T" tube on the
smoke channel every month.
NOTE:
on reaching 200 working hours, the display
will show the writing "CLEAN".
The boiler will continue to work, but the cli-
ent is invited to carry out accurate mainte-
nance within his/her capabilities.
To eliminate the writing on the display, hav-
ing carried out maintenance, press the "#"
key.
- 76
-