moovo XW4 Instrucciones Y Advertencias Para La Instalación Y El Uso página 16

04. Fix the body of the flashing light to the wall with the relative screws,
routing the cables through the prepared holes.
05. Fig. 30:
a) Connect the wires of the two cables and secure on the terminal
board.
b) Lock the cable by means of the relative cable clamp.
30
06. Fig. 31:
Insert the cap of the flashing unit in its seat until the tabs click in
place.
31
07. Fig. 32:
Refit the transparent cover in its seat and turn clockwise, taking care
that the serrated section engages with those on the flashing light
body.
32
16 – English
08. Fig. 33:
On the gearmotor with control unit, loosen the cable clamp at the
centre and pass the connection cable of the flashing light through the
hole.
33
09. Fig. 34:
a) On the control unit, remove the BUS connection terminal board
from its seat to enable loosening of the 2 terminal screws.
b) Proceed with connection of the cable wires, observing the sym-
bols on the terminal board and refit the latter in its seat.
c) Then tighten the cable clamp to secure the cable to the gearmo-
tor.
34