Wall Mounting - Avaya KB 22 Manual De Manejo

- Setting -
3.5

Wall mounting

KB22 is prepared for wall mounting. Using a drill
and two screws (not supplied) the KB 22 can be
easily mount directly on the all. Drill two holes 100
mm apart at the desired mounting location , one
above the other. Thread a screw into each hole
until the screws head extends about 5 mm from
the wall. Line up the keyhole slots on the bottom
of the telephone with the screws on the wall, then
slide the telephone down onto the screws until it is
secure. Plug the telephone line cord into a wall
jack.
In case of using on a table the receiver hanging
hook must be in the position shown in diagram A
(factory setting).
When mounting on the wall the telephone receiver
hanging hook has to be pulled out and rotated.
(Refer to diagram B)
A B
17