Operation; Preliminary Procedures - EMAK IC2050 Manual De Istrucciones

• This appliance is not to be used for spraying:
- water based solutions whose density and viscosity is greater than that of water;
- chemical solutions if their compatibility with the materials that the appliance is made
of, is not known;
- seawater or water with a high salt content;
- all fuels and lubricants;
- inflammable liquids or liquid gas;
- liquids meant for human consumption;
- all solvents and diluents;
- all non-soluble paints and varnishes;
- liquids at a temperature above 40°C or below 5°C;
- liquids containing granules or suspended solid matter.
• The appliance must not be used to wash people, animals, energized electrical appliances,
delicate objects or the appliance itself.
• The accessories (standard and optional) used with the appliance must be those endorsed by
the Manufacturer.
• The appliance is not suitable for use:
- in situations where certain conditions may be found such as in corrosive or explosive
atmospheres;
- in a closed space if it is fitted with a combustion engine.
• Contact the Manufacturer's service centre before use on board vehicles, ships or airplanes,
as there may be additional instructions for use.
Any other use is considered improper.
The Manufacturer is not liable for any damage caused by improper or incorrect use.

4. OPERATION

4.1 PRELIMINARY PROCEDURES


CAUTION
• Check that all the delivery outlets are closed or connected to closed applications (for
example closed tap (36) or spray lance in its closed position).
• Check that all the hooks (34) located on the control unit have been inserted correctly.
Particular attention must be paid to any control units that are secured to the pump by
means of a hook.
• Check the grips that connect the hoses to their respective couplings are fastened down
tightly.
• Make sure the appliance's moving parts are suitably protected and are not accessible to
unauthorised personnel.
• Do not use the appliance if:
- the power supply cable or other important parts, such as the high pressure delivery
hose (1), the safety devices or the lance, are damaged;
- it has been tipped over or has been bumped;
- there are obvious leaks of oil.
- there are obvious leaks of liquid.
In these circumstances, the appliance should be tested by a Skilled Technician.
• Under no circumstances should the inflation pressure of the pressure accumulator (43)
(when present) exceed the maximum values shown in the table below.
• Make sure the special maintenance checks are carried out by a Skilled Technician.
36