Preparing Chemicals For Spraying - EMAK IC2050 Manual De Istrucciones

the country where the appliance is to be used. It is especially important that regulations
are followed concerning its connection to earth, protection by a suitable fuse and magneto-
thermal differential circuit breaker, whose sensitivity is not in excess of 30 mA, and the
insulation of the appliance from the mains electricity with a universal switch with 3 mm
minimum opening between its contacts.
Note: to facilitate the reader, these operating and maintenance instructions always assume
that the appliance is connected to the electrical supply with a plug.
If the appliance is connected permanently to the electrical supply, it is presumed that:
- when the universal circuit breaker is in the off position ('0' position) it is equivalent
to the plug being disconnected from the current outlet.
- when the universal circuit breaker is in the on position ('1' position) it is equivalent
to the plug being inserted in the current outlet.
• If the power supply cable is too short, an extension cord can be used provided it is no
longer than 50 m /164 ft, the section of the wires is at least 1.5mm² and the plug and the
socket are waterproof. Contact a Qualified Electrician to ensure all these requirements are
met.
• The use of unsuitable extension cords can be dangerous.
• Do not use adaptors between the electric plug and the current outlet.
WARNING
• For electric appliances with three-phase motors, particular attention must be paid to ensure
the direction of rotation of the motor corresponds to that shown on the reducer. If this is
not the case, contact a Skilled Technician who will be able to solve the problem by simply
inverting a wire inside the power plug. Failure to comply with the above will result in
considerable damage to the appliance.

4.1.2 Preparing chemicals for spraying


CAUTION
• Keep products in a ventilated place with a door that can be locked. Products must be kept
out of reach of children and unauthorised adults. Appropriate warning notices should be
placed outside to inform of the danger.
• Read instructions and safety information provided on the chemical product's container
carefully so that the most appropriate action may be taken to avoid endangering oneself or
the environment. It is especially important that the maximum recommended concentrations
are not exceeded, that only the amount of product needed for the treatment is prepared and
that spillages onto soil and into water are avoided.
• Should chemicals come into contact with your eyes, wash immediately with water. Contact
a doctor without delay and remember to take the product's container with you.
• Should chemicals be swallowed, do not provoke vomiting. Contact a doctor without delay
and remember to take the product's container with you. Avoid inhaling the fumes that
develop by using appropriate equipment for personal protection (a mask, for example).
Drinking, eating and smoking are prohibited.
• Always wear suitable protective clothing and keep children, unauthorised adults and
personnel without protection at a safe distance.
• Always wash your hands and face carefully after finishing work.
• All garments that have come into contact with chemicals must be washed thoroughly. Any
item that may have been contaminated must be cleaned immediately.
• The containers used for chemicals must be disposed of according to current legislations in
the country where the appliance is used.
38