Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
D-Fi™ 2.4 Ghz
(DMX Mode
Auto Sync)
Freedom™ PAR/Strip Mini User Manual (Rev. 8 ML)
The Freedom™ PAR and Strip Mini offer wireless control of 2 or more products with a
single DMX controller. To automatically set up D-Fi™ 2.4 GHz syncing for DMX, do the
following:
For the transmitting product:
1.
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
3.
4.
Press <UP> or <DOWN> until S-tr appears on the display.
5.
Press <ENTER>.
6.
Press <UP> or <DOWN> until dtA.S appears on the display.
7.
Press <ENTER>.
8.
The display should show dt.AU.
For the receiving product(s):
1.
Press <MODE> repeatedly until SYS, ACt, SLAv or S-1r shows on the display.
2.
Use <UP> or <DOWN> to select SYS.
3.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
4.
5.
Press <ENTER>.
6.
Press <UP> or <DOWN> until dRA.S appears on the display.
7.
Press <ENTER>.
8.
The display should show dR.AU.
Once the steps above are done, press and hold <AUTO> on just the transmitter and for
approximately 30 seconds. The display and signal LED will flash to indicate sync is
activated.
You can then back out to a general menu level and configure the transmitting product to
operate it with a DMX controller.
To configure your product to work with DMX, refer to the
To add additional Freedom™ products, turn the synced ones off and repeat the above
steps with unsynced products. Once all products are synced, turn them all back on.
Auto scan syncing must be done within a distance of about 32 ft (10 m).
Manual syncing is recommended for best results when adding products after
initial sysem setup.
If you are experiencing antenna issues or need to improve signal quality, extend the
antenna outward away from the product and keep the line of sight between products
unobstructed.
Ensure that all linked products are configured to the same DMX personality (either
3-channel or 4-channel).
Caution: D-Fi™ 2.4 GHz operation can be interrupted or inhibited by liquid masses
between the transmitter and receiver such as water, snow, or people. For best results,
keep the antenna clear of any liquid mass.
Starting Address
section.
Page 19 of 76
Publicidad
Tabla de contenido
