Mounting; Orientation; Rigging - Chauvet FREEDOM PAR Manual De Instrucciones

Mounting

Orientation

Rigging

Mounting Diagrams
Freedom™ PAR/Strip Mini User Manual (Rev. 8 ML)
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
The Freedom™ PAR and Strip Mini may be mounted in any position; however, make
sure adequate ventilation is provided around each product.
• Before deciding on a location for each product, always make sure there is easy
access to the product for maintenance and programming purposes.
• Make sure that the structure or surface onto which you are mounting the product
can support the product's weight. Refer to the
this manual for weight information.
• When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, whether an elevated platform or a truss.
• When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The bracket has a 13-mm hole, which is appropriate for
this purpose.
• When power linking multiple products, you must always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
• The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
• The tilt angle adjustment knob on the Freedom™ PAR enables fine adjustment of
the light angle. Loosen the adjustment knob to move the upper area of the
Freedom™ Par to your desired angle.
• The double-bracket yoke on the Freedom™ Strip Mini also serves as a floor support
or allows for surface mounting. When mounting the product on the floor, make sure
that the product and cables are away from people and vehicles.
Bracket
Adjustment Knob
Mounting Bracket
Technical Specifications section of
Tilt Angle
Adjustment Knob
Mounting Bracket
Bracket
Adjustment Knob
Page 13 of 76