Calibrating The Pen (Eb-585Wi/575Wi Only) - Epson EB-585Wi Guia De Instalacion

Installation Guide
d
Adjust the focus to match the focus in the following figure (
Open the air filter cover, and then adjust the focus.
"Adjusting the Projection Position"
s
When ( ) is in focus, check the (
until the ( ) areas are uniform.
After you finish making adjustments, close the air filter cover.
e
Press the [Esc] button on the remote control or the control panel to remove the Test Pattern
This completes adjusting the projected image. When using EB-585W/580/575W/570, attach the covers.
"Attaching the Covers"
s

Calibrating the Pen (EB-585Wi/575Wi only)

For models that support the Easy Interactive Function (EB-585Wi/575Wi), you need to calibrate the interactive
pen.
Check that adjusting the projected image is complete before you start calibrating the interactive pen.
"Adjusting the Projected Image"
s
There are two methods available for calibrating the pen; Auto Calibration and Manual Calibration. When
calibrating the pen for the first time after installing the projector, perform Manual Calibration for optimum
calibration.
For the Auto Calibration method, see the projector's User's Guide (on the Document CD-ROM).
a
Turn on the projector, and then press the [Menu] button
Using the Remote Control
p.37
) areas. If any of the (
p.48
p.37
Using the Control Panel
) areas are out of focus, adjust the focus
44
)