Maytag MAV-17 Manual Del Usuario página 9

To remove the dispenser
for cleaning
1. Support the bottom of the dispenser with
one hand. Use a quarter and turn four
slotted screws counter clockwise 1/4
turn (figure 4).
2. Pull the dispenser out from the bottom
of the lid.
3. Remove fill cap.
4. Fill with water about half way. Move the
dispenser from side to side to wash out
detergent.
5. With the dispenser over a large sink or
bath tub, turn it upside down to empty
the water/detergent out of the dispenser
fill area.
NOTE:
If you decide to change brands of liquid
detergent (Example: Tide
®
Tide with Bleach Alternative
is important the dispenser be empty
and clean before adding new deter-
gent. Different detergents may interact
and clog the dispenser.
Figure 4
To Replace the dispenser
1. Place the top of the dispenser in the top
lip of the lid.
2. Push the bottom of the dispenser into
the bottom of the lid.
3. While supporting the bottom, use a
quarter and turn each of the four screws
1/4 turn clockwise to lock the dispenser
to Wisk or
®
into place.
® to Tide ® ) it
4. Close the washer lid.
5. Open the washer lid.
6. Press the "PUSH" button to release any
remaining water/detergent. Repeat
steps 4–6 until no more water can be
drained from the dispenser. It is normal
for a small amount of water to remain in
the dispenser after cleaning.
7. Refill the dispenser with your favorite
detergent (see page 7).
8