Product Safety Information; Product Specifications; Installation And Lubrication - Ingersoll Rand 318A Especificaciones Del Producto

Product Safety Information

Intended Use:
These Air Sanders are designed for both light and heavy sanding jobs such as roughing body
filler, removing rust, and smoothing welds.
These Air Polishers/Buffers are designed for buffing and polishing paint, metal, and plastic
surfaces to a high-gloss finish.
For additional information refer to Product Safety Information Manual Form 04580387.
Manuals can be downloaded from ingersollrandproducts.com

Product Specifications

Free
Speed
Model
rpm
318A 2500
319A 5000
† K = 3dB measurement uncertainty
pA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16597148 and table on page 2. Maintenance frequency is shown in
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5 . Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
04580577_ed4
Spindle Pad
Size Size
inch inch † Pressure (L
5/8 - 11 7
5/8 - 11 7
WARNING
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - Remove Housing Nut and lubricate Gearing
Sound Level dB (A)
(ISO 15744)
) ‡ Power (L
p
85 96
85 96
‡ K = 3dB measurement uncertainty
wA
EN
Vibration Level
(ISO28927)
) m/s²
w
<2.5
<2.5
EN-1