General Operation - Ingersoll Rand EXPERT TORQUE TESTER Serie Manual Del Usuario

1. To Power Up tester, press
2. Press this icon to enter the Menu structure
and to check and/or adjust parameters.
Pressing this
will then exit the program out of the Menu
structure while returning you to the Run screen.
3. The 4 sub menus can be scrolled through by
using the (2) two arrow keys shown here:
4. Press this icon to progress 1 step into the
Menu structure and this
step in the Menu.
5. For increased security, the operator must first
press this icon. Operator can use the
arrow keys to change the unit's thresholds, as
well as to modify the unit's minimum and
maximum values found in the setup menu.
6. Press this icon to toggle between
clockwise and counterclockwise
measurements.
7. Press the icon to manually reset the unit
for another run, or to adjust the cycle end
time in the setup menu for the desired time.

GENERAL OPERATION

icon.
icon while in the Menu screen
icon to regress 1
8. Press this icon to toggle between the
Peak, Click, Impulse and Track modes.
Notes:
1. Unit will operate for 8 hours under normal
use without adapter. It is best to consume
most/all of the battery's power, then charge
it completely (approximately 4 hours). The
unit can always be used with the adapter.
Use only the adapter supplied by IR.
2. When changing mode, the Frequency
Response reverts to:
Peak, Track and Click 527 Hz
Impulse
It may then be modified using the menu.
3. When changing mode, the Cycle End Time
reverts to:
Peak and Impulse
Click
It may then be modified using the menu.
4. When changing mode, the Sample number
on the display Sam reverts to 1.
4
1676 Hz
0.5 sec
1.0 sec