D Using The Built-In Flash - Canon EOS 7D Mark II Guía De Instrucciones

D Using the Built-in Flash

In the <A> mode, the built-in flash will be raised and fire automatically
in low-light or backlit conditions. You can also enable or disable the
flash firing.
The table below shows the shutter speed and aperture settings that will
be used with flash.
Shooting Mode
A
d
s
f
a
F
In the <d> <s> <f> <a> <F>
modes, just press the <D> button to raise
the built-in flash for flash photography.
Before shooting, check that [D] is displayed
in the viewfinder. After shooting, push the
built-in flash back down with your fingers
until it clicks into place.
Shutter Speed
Automatically set
Automatically set
(1/250 sec. - 1/60 sec.)
Manually set (1/250 sec. - 30 sec.)
Automatically set
(1/250 sec. - 30 sec.)
Manually set (1/250 sec. - 30 sec.)
Exposure continues while you hold
down the shutter button or while
the bulb timer is operating.
Aperture
Automatically set
Automatically set
Automatically set
Manually set
Manually set
Manually set
125