Installing And Removing The Battery - Canon EOS 7D Mark II Guía De Instrucciones

Installing and Removing the Battery

Load a fully-charged Battery Pack LP-E6N (or LP-E6) into the camera.
The camera's viewfinder becomes bright when a battery is installed,
and darkens when the battery is removed.
Installing the Battery
Only Battery Pack LP-E6N/LP-E6 can be used.
Removing the Battery
32
Open the cover.
1
Slide the lever as shown by the
arrows and open the cover.
Insert the battery.
2
Insert the end with the battery
contacts.
Insert the battery until it locks in
place.
Close the cover.
3
Press the cover until it snaps shut.
Open the cover and remove the
battery.
Press the battery lock lever as shown
by the arrow and remove the battery.
To prevent short circuiting of the
battery contacts, be sure to attach the
provided protective cover (p.30) to
the battery.