Installing And Connecting Keypad Mod. Mk - moovo LN4 Serie Instrucciones Y Advertencias Para La Instalación Y El Uso

6.4 – INSTALLING AND CONNECTING
KEYPAD mod. MK
The control keypad is a wall-mounted device used for control of the
automation via a Bus connection. Up to 4 keypads can be connected in a
single system and the device can be programmed to operate in two
modes: Traditional mode (each key performs a specifically assigned func-
tion– factory set) and safety mode (to activate a manoeuvre, a secret key
sequence must be entered, as set by the user).
The keypad is backlit for poorly lit conditions.
To install and connect the keypad proceed as follows:
01. Fig. 32:
Remove the keypad cover by pushing down one side as shown in
the figure.
32
02. Fig. 33:
Using a screwdriver, open and detach the base of the keypad.
33
03. Fig. 34:
a) Drill a hole on the pre-cut section on the base for routing the con-
nection cables.
b) Fix the keypad base to the wall with the relative screws, routing
the cables through the prepared hole.
34
16 – English
04. Fig. 35:
a) Connect the cable wires to the respective terminals.
b) Insert the cable connector in the male connector at the rear of the
keypad.
35
05. Fig. 36:
Refit the cover, ensuring that the serrated section engages with that
of the keypad base.
36
06. Fig. 37:
Fix the keypad cover to the base by means of the screw supplied.
Lastly refit the screw cover cap as shown in the figure.
37
Note – To program the keypads in the system, refer to STEP 9.3.