WEG CFW-11 Serie Guia De Instalacion página 14

External Power Supply for Control in 24 V - KVDC-CFW11-1
Step
12
Fit the ribbon-cable on the XC60A connector (P11) of the VDCx board; the connector is
13
14
Connect the supplied 160-mm ribbon-cable (e) to the XC60 connector (CC11) of the VDCx
board, as shown above and snap the plastic cover on the connector.
Make sure the position of the ribbon-cable is as shown in the figure.
14 | CFW-11/CFW70X
Actions/Instructions
Frame sizes A, B and C
located on the upper part of the board.
Frame sizes A, B and C
Snap the plastic cover (g) on the connector.
Frame sizes A, B and C