Label - WEG CFW-11 Serie Guia De Instalacion

External Power Supply for Control in 24 V - KVDC-CFW11-1
Step
18
Assemble the lower cover and tighten the four screws at the ends of the front covers.
19
Assemble the front cover of the control rack, tighten the two screws and fit the HMI in.
Figure 3: Instructions to assemble the KVDC kit on the inverters with frame size D and E

4 LABEL

Put the two labels (i) supplied with the product after installing the kit on the inverter.
Those labels indicate that the inverter features the KVDC kit, which was not supplied from factory.
The labels must be put next to the product identification labels: one close to the big label, located
on the side of the inverter, and the other close to the label located under the HMI.
26 | CFW-11/CFW70X
Actions/Instructions
Frame sizes D and E
Frame sizes D and E