External Power Supply for Control in 24 V - KVDC-CFW11-1
Step
13
- Connect the supplied 160-mm ribbon-
cable to the XC60 connector (CC11) and
snap the plastic cover on.
- Fasten the clamp, fixing the ribbon-cables
Make sure the position of the ribbon cable is
as shown in the figure.
14
24 | CFW-11/CFW70X
Actions/Instructions
Frame size D
as indicated.
Frame sizes D and E
Assemble the upper front cover.
Frame size E
- Connect the 260-mm ribbon-cable that was
removed in step 8 to the XC60 connector
(CC11) and snap the plastic cover on.
- Fasten the clamp, fixing the ribbon-cables
as indicated.
Make sure the position of the ribbon cable is
as shown in the figure.