WEG CFW-11 Serie Guia De Instalacion página 22

External Power Supply for Control in 24 V - KVDC-CFW11-1
Step
9
Height of the spacers: 28 mm.
Screw the metal spacer (b) where previously
the ground screw was located and fit the
three plastic spacers (c) as shown above.
10
22 | CFW-11/CFW70X
Actions/Instructions
Frame size D
Only frame size D
Position and fit the insulation (d) on the spacers.
Frame size E
Height of the spacers: 35 mm.
Screw the two metal spacers (b) ) where
previously the ground screws were located
and fit the plastic spacer (c) as shown above.
Fit the 160-mm ribbon-cable (e) to the board
of interface with the power (DFOx) and snap
the plastic cover (g) on the connector.
Note: For 690 V models, screw the metal
spacer (b) where previously the ground screw
where located and fit the two plastic spacers
(c). The lower metal spacer was replaced by
a plastic spacer.