1. Mount the ISO Brackets to the radio using the
screws supplied with the radio. (Figure A)
2. Slide the radio into the housing until the side clips
engage. (Figure B)
3 Snap the trim plate onto the front of the radio
housing. (Figure B)
4. Aura, Cobalt, G5, HHR, Sky and Vue only:
Cut and remove top mounting tabs on each side
of the Radio Housing. (Figure C)
5. Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
adapter from Metra or AXXESS. Re-connect the
negative battery terminal and test the unit for
proper operation.
6. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-3302
ISO radio provision with pocket
Refer also to the instructions included with the aftermarket radio.
(Figure A)
(Figure B)
15
Right side clip
(Figure C)
Cut top two holes off