Kit Assembly - Metra 99-7504 Instrucciones De Instalación

DIN radio provision with pocket
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the radio
housing and secure by bending the
metal locking tabs down. (Figure A)
3. Slide the radio back into the sleeve
until it clicks in. (Figure B)
4. Locate the factory wiring harness
and antenna connector in the
dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation.
5. Attach (2) panel clips supplied
to the rear of the radio housing,
and then reassemble the dash in
reverse of disassembly. (Figure C)

Kit Assembly

(Figure A)
(Figure B)
(Figure C)
99-7504
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Secure the ISO brackets to the
radio using the screws supplied
with the radio. (Figure A)
3. Slide the radio into the radio
housing until it snaps into place.
(Figure B)
4. Attach the ISO trim plate supplied
with the kit to the front of the radio
housing. (Figure B)
5. Locate the factory wiring harness
and antenna connector in the
dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation.
6. Attach (2) panel clips supplied
to the rear of the radio housing,
and then reassemble the dash in
reverse of disassembly. (Figure C)
3
(Figure A)
(Figure B)
(Figure C)