Print Head & Rollers - Brother P-touch 1750 Manual De Instrucciones

Occasionally, specks of dust or dirt become attached to the machine's print head and rollers.
This is particularly likely when you are using the unit outdoors or in a very dusty environ-
ment. If a section of the print head is covered with dust, a blank horizontal streak may
appear through the label text. Therefore, as with a tape recorder, the machine's head may
need to be cleaned from time to time.
To clean the print head and rollers:
1
Turn off the machine.
2
Open the tape compartment cover, then remove the tape cassette if one is installed.
The print head and rollers are located in the tape compartment.
3
Print head: Use a dry cotton swab to gently wipe the print head with an up-and-down
motion.
Rollers: Use a dry cotton swab to wipe each roller with an up-and-down motion while
rotating them with your finger.
4
Install a tape cassette, close the tape compartment cover, and then try printing again.
5
If dust still remains, repeat steps 3 and 4 using a cotton swab dipped in isopropyl
(rubbing) alcohol.
If none of the above works, contact your service representative.
Cleaning can also be done by using the optional print head cleaning cassette (TZ-
CL4).
8
PRINT HEAD & ROLLERS
Print head
Print head
Cotton swab
Rollers