EdilKamin MYA Instalación Uso Y Mantenimiento página 40

POSSIBLE TROUBLESHOOTING
heck the pellet type
heck for anomalies with the smoke e traction motor
heck to see if there are any obstructions in the smoke channel
heck correct installation
ear motor faulty ( A )
check maintenance status of the button and its board connection cable (DEALER).
he buffer battery of the control board needs changing (DEALER).
Remember that this component is subject to regular wear and so it is not covered by the guarantee.
gear motor..
heck functioning ( A ): gear motor - Electrical connections and electronic board.
gear motor.
heck functioning ( A ): gear motor - pressure switch - tank thermostat - electrical connections and electro-
nic board
Move closer to the stove
check the battery and if necessary, replace it.
Synchronisation with automatic search on activation: when you put the batteries into the radio control a
radio channel search phase will start up automatically, and it will subsequently connect to the product de-
tected. So that this occurs correctly, make sure to switch the product on before inserting the batteries in the
radio control, and stay in the vicinity of the antenna in order to achieve radio coverage with certainty.
Synchronisation with automatic search and manual activation - it is possible to launch an automatic search
for a product manually, simply carry out the following operations after having already put the batteries into
the radio control:
- o close to the product s antenna and make sure it is connected to the electricity supply.
- With the display switched off (standby) hold the 0 I key down for 10".
- After 10" a "NE WORK SEAR
that the automatic search has been activated.
- Automatic tuning of the radio channel will occur within a few seconds.
heck the condition of the ignition coil, the electrical system, and the electrical components.
heck that the fan is working.
NOTA 2
NOTA 3
N. .
The combustion chambers and smoke ducts connected to the solid uel appliances must be cleaned once a year (check
i your country has speci c legislation covering this .
Failure to regularly check and clean increases the likelihood o a re in the chimney pot.
In the case o a re in the stove, in the ue or in the chimney, proceed as ollows
- Disconnect the power supply
- Use a carbon dio ide (CO
2
- Call the re brigade
DO NOT ATTEMPT TO PUT THE FIRE OUT WITH WATER!
A ter the event, have the appliance checked by an authorised Service Centre and have an authorised technician check the ue.
(signals an anomaly on the emergency button)
Activated when anomalous, e cessive current absorption is detected on the
Activated when anomalous, insuf cient current absorption is detected on the
IMPORTANT!!!
e tinguisher
" message appears on the display, then release the o I key, as this means
- 40
-