EdilKamin PELLBOX SCF Instalación Uso Y Mantenimiento página 26

Automatic operation using the remote control
Press the Menù key to switch to automatic operation and set the temperature required in the room (to adjust the tempe-
rature from 5°C to 35°C use the + and -). The insert adjusts its working power to reach the temperature set (POWER 3
or maintain POWER 1).
If the temperature set is lower than in the room, the insert runs at P1.
Switching off
Hold the 0/1 key down on the display-control panel or remote control for two seconds while the insert is operating. The
shutdown procedure starts and a countdown from 600 to 0 appears on the display (for a total of 600 seconds).
During shutdown:
• Pellet loading ceases.
• Ventilation turns up to maximum
• The smoke expulsion motor turns up to maximum.
Never unplug the insert while it is shutting down.
GENERAL INSTRUCTIONS OF USE
: ignition / shutdown button (press for approximately 1 second) this button can also be pressed toexit the
programming menu
+
:
button to increase the power/operating temperature (when inside a menu, it increases the displayed variable)
-
:
button to decrease the power/operating temperature (when inside a menu, it decreases the displayed variable)
A :
button to switch to the "EASY TIMER " program
M :
button to toggle from automatic to manual mode and vice versa
DESCRIPTION OF DISPLAY SYMBOLS OF THE REMOTE CONTROL
Indicates data transmission between the remote
control and the control board.
low batteries; replace them and put them in their
appropriate containers.
blocked keypad; avoid turning on the remote control
for no reason (press "A" and "M" simultaneously for
a few seconds to block/unblock the keypad)
Indicates that ignition / shutdown is being via the
"EASY TIMER" program
Indicates that a setting has been transmitted for
the insert/stove to ignite
fan speed indicator
pellet/water thermo stove remote control
setting indicator
pellet/water stove remote control setting indicator
automatic function
(the temperature value appears on the display)
manual adjustment function
(the operating power value appears on the display)
Indicates the room temperature detected by the
remote control (it indicates the values of the set
parameters during its technical set-up).
26