EdilKamin PELLBOX SCF Instalación Uso Y Mantenimiento página 28

OPERATIONS WHICH CAN ONLY BE CARRIED OUT USING THE REMOTE CONTROL
Clock adjustment
Hold the menu key down for two seconds to access the clock menu. and set the internal clock on the electronic circuit
board.
Press the menu key repeatedly to display and set the following parameters in the order shown:
day, month, year, hour, minutes, and day of the week.
Once done, "Save??" appears on the display. Make sure the changes made are correct and confirm by pressing the menu
key (the word "Saved" then appears).
Weekly time programmer
Press the menu key on the remote control for two seconds to access the time setting function and press the + key to access
weekly time programming: the message "Program on/off" appears on the display.
The insert may be programmed to come on and switch off automatically up to three times a day on each day of the week.
Confirm this by pressing the Menu key. One of the following possibilities appears:
NO PROGRAM (not programmed)
DAILY PROGRAM (programmed to do the same thing every day)
WEEKLY PROGRAM (programmed differently for each day)
You can go from one to another using the + and - keys.
Confirm the "DAILY PROGRAM" option with the menu key to choose the number of programs (on/off) per day.
If you confirm "DAILY PROGRAM", the program(s) set will be the same every day of the week.
Press the + key repeatedly to display:
- No program
- 1st program (one ON and one OFF per day), 2nd program (ditto), then 3rd program (ditto)
Using the - key displays the items in reverse order.
If 1st program is selected, the ON time is displayed.
The display shows: 1 ON hour 10,30; use the +/ - keys to change the hour and press the menu key to confirm.
The display shows: 1 ON minutes 10,30; use the +/ - keys to change the minutes and press the menu key to confirm.
Proceed in the same way to program the OFF time and the other program times.
When Save?? appears on the display, confirm the changes by pressing the menu key.
After confirming "WEEKLY PROGRAM", choose the day the program applies to:
1 Mon, 2 Tue, 3 Wed, 4 Thu, 5 Fri, 6 Sat and 7 Sun
Once the day has been selected using the + and - keys and confirmed with the menu key, continue in the same way as
for the "DAILY PROGRAM". Choose the number of programs and the times for each day of the week.
If you make a mistake while programming, you can quit by pressing the 0/1 key: the display shows "Saved".
The operations described here (power/temperature and ventilation adjustment, clock adjustment, programming on/off
times, changing pellet load, cold tests and parameter adjustment) may only be carried out using the REMOTE
CONTROL.
To use the remote control, point it towards the insert. A beep confirms command reception, which is also confirmed
by the command taking place.
The most frequent cause of remote control malfunction is flat batteries. Replace and dispose of used batteries
suitably.
Change pellet load
Press the menu key on the remote control for two seconds and scroll through the items using the +/- keys until "ADJ-
PELLET" appears on the display.
Confirm this item by pressing the menu key. The pellet load setting appears. Decreasing the setting decreases the pellet
load; increasing the setting increases the pellet load. This function may be useful if the type of pellet the insert has
been calibrated for is changed, thus making load adjustment necessary.
If adjusting this setting is not sufficient, contact the DEALER for a new operating setup.
28