EdilKamin FANTASY Instalación Uso Y Mantenimiento página 46

POSSIBLE TROUBLESHOOTING
) Signalling: s o e C high.
Proble : turns off due to exceeding
Actions:
hec the pellet type
hec for anomalies with the smo e e traction motor
hec to see if there are any obstructions in the smo e channel
hec correct installation
hec gear motor "drift
hec to ma e sure there is an air inta e in the room
8) Signalling: ALARM - HIGH CURRENT: Activated when anomalous, excessive current absorption is detected on the
gear motor..
Actions:
Check functioning (CAT): gear motor - Electrical connections and electronic board.
9) Signalling: ALARM - LOW CURRENT:
gear motor.
Actions:
Check functioning (CAT): gear motor - pressure switch - tank thermostat - electrical connections and electro-
nic board
1 ) Signalling: Battery chec
Proble : The insert does not stop but the error appears on the display.
Actions: he buffer battery of the control board needs changing ( E LER).
Remember that this component is subject to regular wear and so it is not covered by the guarantee.
11) Proble : Re ote control not wor ing
Actions:
closer to the receiver of the insert
chec the battery and if necessary, replace it.
12) Proble : Outlet air not hot
Actions:
clean heat e changer from inside the rebo .
1 ) Proble : uring ignition the differential switch trips ( EALER):
Actions:
chec moisture content of ignition resistance
1 ) Proble : oes not ignite:
Actions: clean combustion chamber.
NOTA
arnings are shown until you intervene and press the 1 ey on the control panel.
o not ignite the stove until the proble
N.B.:
The combustion chambers and smoke ducts connected to the solid fuel appliances must be cleaned once a year (check
- Use a carbon dioxide (CO
2
DO NOT ATTEMPT TO PUT THE FIRE OUT WITH WATER!
axi u s o e te perature.
has been chec ed and resolved.
IMPORTANT!!!
- 46
-