Power Regulation; Turbo Function; Turning Off - EdilKamin PELLET-BLOK Instalación Uso Y Mantenimiento

1 st ignition/test by the Edilkamin authorised Dealer
Start-up must be carried out as prescribed by point 3.21 of standard UNI 10683.
This standard indicates the control operations to be carried out in situ, aimed at ascertaining correct system function.
Filling the cochlea.
The first time you use the product, or should the tank be completely emptied of pellets, to fill the coclea press both keys
"+" and "–" on the remote control at the same time, holding for a few seconds. As you release the keys, the display
should show the wording "LOAD".
This should be carried out before ignition if the fireplace has stopped due to having run out of pellets, at the end of ope-
ration to empty the combustion pot before turning.
It is quite normal for some pellets to remain, that the cochlea cannot suction.
Automatic igniting.
With the fireplace on stand-by, press and hold the key
ignition procedure, showing the wording "START". At the same time, a countdown in seconds begins (from 1020 to 0).
Ignition is not at a preset time, however: its duration is automatically shortened if the board reports that certain tests have
been passed. The flame appears after about 5 minutes.
Manual igniting.
Temperatures of below 3°C will not allow the electrical resistance to heat sufficiently. In this case, or should the
resistance be temporarily out of action, Diavolina® type fire-starters can be used.
Insert a piece of lit Diavolina® into the combustion chamber, close the door and press

POWER REGULATION

Remote control manual operation
•
With the fireplace working, press the key "M" on the remote control once.
The display will show the word "POWER P".
(specifying the power at which the fireplace is working). Press the keys "+" or "–" to increase or decrease the fireplace's
working power (from "POWER P1" to "POWER P5").
Remote control automatic operation
•
Press key "A" to switch to automatic operation, adjusting the temperature desired for the room (use the "+" and "–" keys
to set the temperature from 5°C to 35°C, and the insert will regulate working power required to reach the temperature
set. If a temperature below that of the room is set, the fireplace will stay on "POWER P1".

TURBO function:

•
Press the "M" button to also access the "TURBO" function menu, use the + / - buttons to enable (ON) or disable (OFF)
the TURBO function, which increases the level of ventilation.

Turning off

With the fireplace running, press and hold the key
The turn-off procedure will begin, showing a countdown on the display from 9 to 0 (for a total of 10 minutes).
The turn-off phase involves:
• Interruption of pellet supply
• Maximum ventilation.
• Smoke expulsion motor.
Never pull the plug out whilst the device is still in the process of turning off.
INSTRUCTIONS FOR USE
from the remote control for 2 seconds.
, on the remote control for 2 seconds. This will start-up the
32
the remote control.