Model 3675 - Lincoln 3675 Manual Del Usuario

Model 3675 (no filter)
Wheels
1. Remove the nut (11) and lock washer (10)
from the wheel shaft, leaving the plain
washer (9) on the shaft.
2. Insert the wheel shaft through the hole in
the wheel brace welded to the tank.
3. Slide the lock washer (10) onto the wheel
shaft and screw the nut (11) onto the shaft
thread.
4. Use a 7/8" open-end wrench between the
wheel and the outside of the wheel brace
to hold the shaft, and tighten the nut with a
15/16" open-end or hex wrench.
5. Repeat this procedure for the second
wheel.
Pump
1. Apply PTFE tape to the thread on the 6"
(150mm) long pipe extending from the top
of the tank.
2. Install the pump (18) by threading the inlet
(black bushing and marked "IN") onto the
pipe.
3. Tighten the pump using a 1-3/4" open-end
wrench on the flats of the black bushing.
note: Be sure to orient the pump during
final tightening, so the handle is easily ac-
cessible.
4. Slide the pump handle (19) onto the pump
shaft. Rotate the handle to align the locking
nut with the indentation on the shaft. Tight-
en the locking nut using a 14 mm open-end
or hex wrench.
Filler Pipe
1. Thread the filler pipe (3) into the screened
port on top of the tank.
2. Install the cap (2) onto the top of the filler
pipe.
Form 404223
Vent Cap
1. Thread the vent cap (1) into the open port
(w/o screen) located on top of the tank.
Fluid Transfer Hose
1. Remove the plastic cap from the outlet port
on top of the pump (18).
2. Apply thread tape (included) to the thread of
the fluid transfer hose (20).
3. Thread the hose into the pump outlet port
on top of the pump.
4. Tighten it with a 1-1/6" open-end wrench.
Handle and Ground Wires
1. Insert the handle (4) into the brackets
welded to the side of the tank.
2. Slide the ground wire eyelet (15) and a
plain washer (6) onto one of the machine
screws (7).
3. Insert the screw from the outside in,
through the hole in the handle and bracket.
4. Slide a second plain washer (6) onto the
end of the screw and secure the assembly
with a nut (5).
5. Perform the same operation on the oppo-
site bracket, excluding the ground wire.
Page number - 5