Model 3677; Operation - Lincoln 3675 Manual Del Usuario

Model 3677 (with 2-Way filter)
Follow the assembly steps for the Wheels, Pump, Filler Pipe and
Vent Cap for model 3675 above.
Handle, Ground Wires and Filter Housing
1. Insert the handle (4) into the brackets welded to the side of the
tank and align the holes in the handle with those in the bracket.
2. Slide the ground wire eyelet (15) and a plain washer (6) onto one
of the machine screws (7).
3. Position and support the filter housing assembly with the mount-
ing brackets located on the inside of the handle brackets (see
Fig. 1)
4. Align the hole through one mounting bracket with the hole
through the mating handle bracket and handle (see Fig. 2), and
insert the machine screw through the entire assembly.
5. Slide on a plain washer (6) and secure with a hex nut (5).
6. Perform the same operation on the opposite bracket, excluding
the ground wire.
7. Wrap the 3/4" NPT Swivel Elbow Fitting (21) with PTFE tape
and install it into the top of the pump (18). Tighten with 1-1/16"
wrench (see Fig. 3).
8. Wrap one end of the filter connection hose (22) with PTFE tape
and install it into one of the filter housing ports using a 1-1/16"
wrench (see Fig. 4).
9. Connect the other end of the hose to the swivel fitting using
1-1/16" and 1-1/4" wrenches (see Fig. 5).
10. Wrap the ¾" NPT thread on the end of the fluid transfer hose
(20) and install it into the opposite end of the filter housing using
a 1-1/16" wrench (see Fig. 6).
11. Lubricate the seal on one of the filters and install it to the filter
housing. Hand tighten (see Fig. 7).
12. Repeat with second filter.

Operation

Set-up
1. Park the vehicle, turn off the ignition, and set the parking brake.
2. Ensure the caddy is properly positioned on level ground within
required reach of the vehicle fuel tank.
3. Connect the ground wires extending from the pump and the
tank handle to a known ground on the vehicle being serviced.
Page number - 6
fig. 1
fig. 2
fig. 3
fig. 4
Form 404223