ECOFOREST TOKIO Manual De Instalación Y Mantenimiento página 34


Stainless steel hose clamp.

T of 135° with outlet.

Wooden ground.

Non flammable floor protection.

Stainless steel flexible tube.

Rigid flexible pole adapter.

Anti blow-back seal.

Minimum 200mm.

It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger

size will be used.
When installing a flexible tube for gas outlet, be careful that this is not in contact or close to the circuit board
or combustible material.
Insert stoves must be equipped with a ventilation grid in the right panel and another one in the upper panel
(minimum dimensions 240x190mm).
To recess the ECO3 models, it is necessary to screw down 2 angle brackets to the floor (  ) and then secure
them with the screws from the front (  ).

Angle brackets fastened to the floor.

Stopper and fastening screws.
Stand-off distances are the same for all models.
PLACING LEGS ON THE CÓRDOBA GLASS AND CÓRDOBA MODELS (OPTIONAL).
Join the 4 legs to form a rectangle with side and front strengtheners as indicated in drawing 12.
Open the stove guides in such a way that we can access the fixing points for the legs at the base of the stove.
The assembly order for the stove resting above its legs will depend on the installer's needs, being able to fix
the legs into place and perform the base assembly later; or either assemble the entire stove and legs and later
position this and fix the legs to the floor. It is compulsory to screw the legs to the floor.
RECESSING THE ECO III INSERT STOVE.
643mm
2 units
33
Drawing 10
Drawing 11