Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INSTRUCTIONS
Congratulations on purchasing the Baracuda
a moment to read through the entire manual before installing your new unit.
Your cleaner must be installed and operated as specified.
READ AND FOLLOW ALL INSTRUCTIONS.
Failure to heed the following warnings can result
WARNING
!
in permanent injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK
• To reduce risk of electrical shock:
- Connect unit to receptacle protected by a ground fault circuit interrupter (GFCI).
- Per United States National Electric Code (NEC), keep the power unit at least
five (5) feet (Canada three (3) metres (ten (10) feet) per CEC requirements) from
pool edge and do not remove it from caddy. Never submerge the power supply.
- Do not enter pool while S3 Robotic is in water.
- Do not bury cord. Locate cord so as to prevent it from being damaged by lawn
mowers, hedge trimmers and other equipment.
- S3 Robotic is designed with double insulation protection. Double insulation is a
concept of safety in electric power products which eliminates the need for the
usual three (3) wire grounded power cord. All exposed metal parts are isolated
from the internal live parts with two (2) insulation layers.
- Double insulation-For continued protection against possible electric shock, use
only identical replacement parts when servicing. Do not attempt repair of the S3
Robotic cleaner, power supply unit, power cord, or floating cable.
- To reduce the risk of electrical shock, do not use S3 Robotic cleaner or power supply
if the cord is worn or damaged. Contact Zodiac Pool Systems, Inc. immediately for a
replacement cord.
- NEVER OPEN POWER SUPPLY UNIT.
- Do not use an extension cord to connect the unit to electric supply; provide a
properly located outlet. The power supply unit shall be placed near the outlet box.
PREVENT CHILD INJURY AND DROWNING
• To reduce the risk of injury, do not permit children to operate this product.
• Do not let anyone, especially small children, sit, step, lean, or climb on any equipment
installed as part of your pool's operational system. Unless otherwise stated, per United
States National Electric Code (NEC), ALL components of your pool's operational system
should be located at least five (5) feet from the pool, three (3) metres (ten (10) feet) in
Canada per the Canadian Electrical Code (CEC), so children cannot use the equipment
to gain access to the pool and be injured or drown.
Failure to heed the following warnings could cause
CAUTION
!
damage to pool equipment or personal injury.
• S3 Robotic must be installed and operated as specified.
• Turn S3 Robotic off before removing it from water, and do not operate out of water.
• Do not remove S3 Robotic from the pool for 15 minutes after the cleaning cycle
has completed.
• Clean filter element in the S3 Robotic after each use.
• Do not use the product in your pool if the water temperature is
above 95˚ F (35˚ C) or below 55˚ F (13˚ C).
SAVE ALL INSTRUCTIONS.
S3 Robotic cleaner. Please take
®
2
3
CONTENTS
2
5
5
5
5
6
6
7
7
8
8
9
9
9
10
11
14
Publicidad
Capítulos
Tabla de contenido
