Klarstein 10033689 Manual De Instrucciones página 33

Figure 6
3. Release the lock, open the lid of the dispenser and place the well-assembled keg
into the cooling cavity. Connect the CO
the keg lifter tube connector.
Note: Make sure all connection of tap mechanism is well connected, and without
damage. And make sure tap valve is on close status, and the CO
knob is at "Off" status.
Close
Open
Figure 8
4. Make sure that the pressure regulator on the lid is in the "-" position. Rotate the
cartridge holder outwardly from the upper cover assembly by an appropriate
angle, not exceeding a maximum angle of 90 degrees (see figure 10). Then
unscrew the cylinder sleeve and install a CO
attached) into the gas bottle (see figure 1 1), and then carefully tighten the cartridge
quickly (clockwise tight, counterclockwise is loose) (figure 12), until you hear a
"click" sound, indicating that the cartridge seal has been pierced and the CO
can flow into the keg freely. The pressure relief regulator assembly is then rotated
upwards and snapped into the upper lid assembly. If the cartridge is replaced,
follow the reverse procedure (make sure the gas is used up when changing the gas
bottle).
Beer connector
Figure 7
connector tube and beer outlet tube with
2
pressure regulator
2
Figure 9
cartridge (with 3 CO
2
CO connector
2
cartridge
2
gas
2
EN
33