Klarstein 10033689 Manual De Instrucciones página 43

Cartridge pierced probe and seal washer
Cartridge pierced probe and seal washer maybe damaged when wrong usage or other
reasons, please replace a new one.
1. Firstly, pick out the seal washer with a tiny metal stick (Show as fi gure 24), and take
out Cartridge pierced probe. Be careful not damage other parts of regulator.
2. Install a new cartridge pierced probe in the regulator (leave the sharp end outside
toward), and install the seal washer (Show as fi gure 25). Don't remove other parts
of regulator in the replacing process.
Figure 24
WARNING
Risk of injury! Remember press the seal circle with empty cartridge
instead of new cartridge, or will cause hazard.
To change beer tube
Please replace the beer tube if beer tube is damaged and cause beer leakage (see
fi gure 26).
1. Loosen the tube at connection 1 and draw out the tube. Pull down the lock setting,
and draw the tube out.
2. Screw out nut at connection 2, and draw the tube out.
3. Replace a new beer tube, and install the beer tube according with reverse
procedure.
Regulator
assembly
Slim metal
stick
Cartridge connector
Seal circle
Empty CO
Figure 25
EN
cartridge
2
43