The Seat - Mutsy igo Manual De Instrucciones

English
· Make sure that the chassis has been
fully unfolded and the brake is blocked
during all actions indicated below.
Place the carry cot (k)
· Place the attachable elements on the
carry cot into the attachment points
on the chassis and press the carry cot
downwards until you hear a click on
both sides.
· Check to ensure that the red sections
on the chassis attachment points are
no longer visible. Check that the carry
cot has been installed securely by try-
ing to lift it from the chassis.
remove the carry cot (l)
· Slide the unlocking buttons upwards
until you hear a click on both sides. Be
careful! The carry cot is now unlocked;
the red sections on the chassis attach-
ment points are now visible. Take the
carry cot firmly by the handle on the
hood and remove it from the chassis in
a vertical movement.
The hood (m)
· The hood can be unfolded by moving it
upwards.
· Push and hold the buttons on the sides
of the hood. The hood can now be fold-
ed downwards.
assemble the rain cover on the carry cot (n)
· Make sure that the hood of the carry cot
has been unfolded.
· Place the rain cover from top to bottom
over the carry cot and make sure that
the rain cover attaches well all around
the bottom of the carry cot.
· Close the Velcro strips around both
sides of the chassis.
· Open the zipper in order to remove your
baby from the carry cot when using the
rain cover.
16
The seat (6 months – 15 kg / 33 lbs)
· The seat is suitable for children from 6
months up to 15 kg / 33lbs who can sit
independently.
· When in the drive position, the seat can
be folded and unfolded with the chas-
sis and does not therefore need to be
removed from the chassis.
· The back support and leg support are
adjustable.
· Make sure that the chassis has been
fully unfolded and the brake is blocked
during all actions indicated below.
Moving the seat unit to face forwards (o)
· Place the attachable elements on the
seat into the attachment points on the
chassis and press the seat downwards
until you hear a click on both sides.
NB! Place both ridges on the attach-
ment elements into the chassis attach-
ment points at the same time.
· Check that the chair has been at-
tached solidly by trying to lift it from
the chassis.
Moving the seat unit to face backwards (p)
· In order to place the seat unit so that it
is facing backwards, the attachment el-
ements on the seat need to be turned
by 90 degrees. Press the button (p1),
the attachment elements will unlock
and spring out. Turn the attachment el-
ements to the correct setting and then
click into place.
· Then place the attachable elements on
the seat into the attachment points on
the chassis and press the seat down-
wards until you hear a click on both
sides. NB! Place both ridges on the at-
tachment elements into the chassis at-
tachment points at the same time.
· Check that the chair has been attached
properly by trying to lift it from the
chassis. NB! The chassis cannot be