Additional Information - Nice Era Mat MHT-USA Serie Instrucciones Y Advertencias Para La Instalación Y El Uso

5) Climate management
Response to sun:
- at the sun overthreshold command by a climate sensor, the motor will carry out the opening of the awning.
- At the sun underthreshold command by a sensor, the motor will carry out the closure of the awning.
Special cases:
The sun is not a blocking event, or better the user may at any time decide to close, open or adjust the opening of the awning as required.
When the climate sensor sends the sun underthreshold command, in any case the motor will carry out the closure of the awning.
Response to rain:
- at the start of rain command by a climate sensor, the motor will carry out a lowering or raising movement according to the direction pre-
viously selected, blocking the command logic related to the sun.
- At the end of rain command, the motor will restore the operation logic of the sun.
Special cases:
Rain is not a blocking event, or better the user may at any time decide to close, open or adjust the opening of the awning as required.
When interacting with the awning by opening or closing it during the raining phase, about each 15 minutes the motor will restore the initial
condition of the event if still present (awning open or closed according to the direction). Rain prevails over the sun.
Response to wind:
- at the wind overthreshold command, the motor will carry out the closure of the awning by blocking the motor commands and the sun/rain
operation logic.
- At the wind underthreshold command, the motor restores the operation logic of the sun/rain unblocking the automation.
Special cases:
Wind is a blocking event, or better it blocks the commands by the user and the sun/rain logics to protect the awning from hypothetical
breakage.
SUN ON Function:
When SUN ON is activated via the remote control, the motor will immediately respond to the climate logic related to the SUN. If the sun was
active the awning will immediately lower, while if the sun was not active nothing will happen.

6) Additional information

The Era Mat MHT-USA series motors recognise the transmitters of the ERGO, PLANO, NICEWAY and VOLO S RADIO series (see chapter
6.1 "Transmitters usable").
A particular command can also be associated to each transmitter button by means of a specific memorization procedure (see chapter 6.2
"Transmitter programming in Mode I and Mode II").
Warning: use transmitters that have been memorised in Mode 1 only for programming.
6.1) Available transmitters
Table A16 indicates the transmitters that can be used with the relat-
ed coding.
Table "A16"
Transmitters
ERGO1 - ERGO4 - ERGO6
PLANO1 - PLANO4 - PLANO6 - PLANO TIME
VOLO S RADIO - NEMO
NICEWAY (the whole series)
FLO1R - FLO2R - FLO4R
VERY VR
6.2) Memorizing the transmitters in Mode I and Mode II
Tables "A1" and "A2" describe the memorization of the transmitters in "Mode I" where a specific command is assigned to each button: but-
ton s (1) = "Up"; button n (2) = "Stop"; button t (3) = "Down".
It is possible to memorise the transmitters also in "Mode II"; this mode allows greater flexibility in using the keys of the transmitters. On the
same Era Mat MHT-USA motor it is possible to memorise transmitters in Mode I and in Mode II.
9
ERGO PLANO
FLO4R VERY
NICEWAY VOLO S RADIO
NEMO