Memory Deletion - Nice Era Mat MHT-USA Serie Instrucciones Y Advertencias Para La Instalación Y El Uso

4.4.7) Modifying position "1"
Follow the procedure indicated in table "A13" to modify position "1":
Table "A13" Modifying position "1"
Press and hold down button n of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds)
Press and hold buttons n t for another 5 seconds until 2 rapid beeps are heard.
2.
At this point the awning automatically moves to the position "1"
Use buttons t and s within 5 seconds to reposition the awning in the new position
3.
to be programmed
Confirm the position by pressing buttons n t of the transmitter together within
4.
5 seconds until 3 beeps are heard and a short up and down movement is performed.
Note: if the programming described in point 4 is not confirmed the modifications are aborted and the previous programming is maintained.
By modifying position "1" the "FRT" and "FTC" functions are cancelled.

4.5) Memory deletion

This procedure can be performed in case it becomes necessary to delete all the data contained in the memory of the control unit in the Era
Mat MHT-USA motors.
The memory can be cancelled:
• with one transmitter already memorised (table "A14")
• with no transmitter memorised (table "A15").
The following can be cancelled:
• The transmitter codes only, ending at step 4
• All data (transmitter codes, positions, RDC function, etc) completing the entire procedure.
Table "A14" Cancellation of the memory with a memorised transmitter
Keep button n of the transmitter pushed until a beep is heard (after approx. 5 seconds).
1.
Keep button s of the transmitter pushed until 3 beeps are heard; release button s on
2.
the third beep.
Keep button n of the transmitter pushed until 3 beeps are heard; release button n on
3.
the third beep.
Ë Keep button t of the transmitter pushed until 3 beeps are heard; release button t on
4.
the third beep.
If you wish to cancel all data, push buttons s and t together within 2 seconds and
5.
then release them.
After a few seconds 5 beeps signals that all codes has been cancelled.
To cancel the memory with a transmitter that has not been memorised:
Table "A15" Cancellation of the memory with a non-memorised transmitter
1. Turn the power supply off for at least 3 seconds.
2. Turn on the power and within 10 seconds rotate the emergency manoeuvre for
at least 6 turns
3. At this point, within 1 minute, it is possible to delete the memory using the procedure
in table A13 with any transmitter, even if not memorised.
If necessary, the awning can be automated using a VOLO S RADIO wind and sun sensor. When the sensor is correctly memorised in the motor
it lowers the awning when there is sun and retracts it when there is wind. Refer to the VOLO S RADIO instructions for the detailed performances
and programming the sensor's levels.
Example
5s
5s
Example
5s
within 2s
Example
3s
x6
within 10s
60s Table "A11"
EN
8