Optional Programming - Nice Era Mat MHT-USA Serie Instrucciones Y Advertencias Para La Instalación Y El Uso

4.3) Awning without box - Manual programming of the positions: "0" (Upper limit switch) and "1"
(Lower limit switch)
To program the positions, a remote control already memorised in mode I must be used. As long as positions "0" and "1" are not memorised
in the control unit, the movements take place in the hold-to-run mode (in the second programming phase of height "0" the motor will not
operate in the hold-to-run mode). Initially the direction of the motor is not defined, but upon completion of point 1 of table "A4" the direction
of the motor is automatically assigned to the keys of the remote controls. Every 100 manoeuvres, the motor will carry out a realignment throu-
gh the impact with the set RDC force.
Table "A4" Programming position "0" e "1"
Press and hold down the s or t key of a memorised remote control until the closure
1.
of the awning is complete and the motor automatically stops against the mechanical
retainer.
Press and hold down the t key that makes the awning lower
2.
Release the t command when the awning has reached the position ("1").
3.
If necessary, adjust the desired position with the t and s keys.
Press and hold down the n key of the transmitter until you hear a beep
4.
(after about 5 seconds)
Release and press the n key again for another 5 seconds until you hear 4 fast beeps
5.
Press the t key until there are 3 beeps and a short raising and lowering movement
6.
Height "1" memorised
Press the s key and stop with the n key the awning at the desired position "0"
7.
Press and hold down the n key of the transmitter until you hear a beep
8.
(after about 5 seconds)
Release and press the n key again for another 5 seconds until you hear 4 fast beeps
Press the s key until you hear 3 beeps.
9.
Height "0" memorised

4.4) Optional programming

Optional programming is only possible after positions "0" and "1" have been programmed.
4.4.1) Memorisation of the intermediate position "I"
When an intermediate position "I" is memorised the awning can be manoeuvred into the "I" position by pressing the s and t buttons of the
transmitter together.
Follow the procedure shown in table A5 to memorise the intermediate position:
Table "A5" Programming of the intermediate position "I"
Using buttons s n t of a remote control, move the awning into the "I" position to
1.
be memorised
Press and hold down button n until you hear a beep (after about 5 seconds)
2.
Release and press again button n for another 5 seconds until 4 rapid beeps are heard
3.
Press buttons t and s together until 3 beeps are heard, indicating that the position
4.
has been memorised
5
Example
5s
5s
5s
5s
Example
5s
5s