Troubleshooting; Safety Notices; Fault Indications - Caso MCDG 25 Master black Manual De Instrucciones

17 Troubleshooting

17.1 Safety notices

17.2 Fault indications

caso MCDG 25 Master black
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
Attention
► Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical
equipment.
► Improperly performed repairs can cause considerable
dangers for the user and damages to the device.
In the event of a fault, an error code will appear in the display; it
describes the cause of the fault.
Error code
E01 Excessive temperature within cooking
chamber
The overheating cut-out terminated the current
program at a cooking chamber temperature of
250°C.
Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool
down phase.
Low temperature protection
E02
When the system enters into super low
temperature protection status, the digital display
shows "E02" and continues to beep till the
system comes back to normal condition and then
press "Stop".
E03 Sensor fault
The device has detected an error on a sensor
and has terminated the current programme.
Press the Stop button to acknowledge this fault.
Description
87