Hca Warning; For Products With A Water Dispenser - Fulgor Milano F6FBM36S1 Instrucciones Para El Uso

Important instructions for safety and environment
since it would get into contact with the electrical
parts in the refrigerator!
ods to accelerate the defrosting process, other
than those recommended by the manufacturer.
the door and drawer as a means of support or
step. This will cause the product to tip over or
parts of it get damaged.
refrigerant is circulating, with drilling or cutting
tools. The refrigerant that might blow out when
the gas channels of the evaporator, pipe exten-
sions or surface coatings are punctured may
cause skin irritations and eye injuries.
the refrigerator with any material.
closed and vertically.
since there is the risk of fire or explosion!
mable gases (e.g. spray) as well as the explosive
materials should never be kept in the appliance.
of the product. Spilling water on an electrical
component may cause electric shocks or risk of
fire.
medicines, scientific materials and etc.) that
require a precise temperature control in the
refrigerator.
period of time, unplug and unload the food in it.
look at the blue light with optical tools.
wind is dangerous with respect to electrical
safety.
stat), wait for minimum 5 minutes to plug in the
product again after unplugging it.
the door is opened, and cause injury or damage.
Similar problems may occur in case of putting
things on top of the product.
do not pull by the handle when changing the
place of the product. Handle may get loose.
your body get caught by the moving parts inside
-
the product.

1.1.1 HCA warning

This gas is flammable. Therefore, pay attention to
not damaging the cooling system and piping during
usage and transportation. In the event of damage,
keep your product away from potential fire sources
that can cause the product catch a fire and ventilate
the room in which the unit is placed.
Ignore this warning if your product's cooling
system contains R134a.
Type of gas used in the product is stated in the type
plate which is on the left wall inside the refrigerator.
Never throw the product in fire for disposal.
C
If the product is equipped with a cooling
system containing R134a gas, ignore this
warning.
-
C
You can learn the gas used in production of
your product on the rating plate located on
the left inner part of it.
A
WARNING:
in fire.
1.1.2 For products with a
water dispenser
Pressure for cold water inlet shall be maximum
90 psi (620 kPa). If your water pressure exceeds
80 psi (550 kPa), use a pressure limiting valve
in your mains system. If you do not know how to
check your water pressure, ask for the help of a
professional plumber.
If there is risk of water hammer effect in
your installation, always use a water hammer
-
prevention equipment in your installation.
Consult Professional plumbers if you are not
sure that there is no water hammer effect in
your installation.
Do not install on the hot water inlet. Take
precautions against of the risk of freezing of
the hoses. Water temperature operating interval
shall be 33°F (0.6°C) minimum and 100°F
(38°C) maximum.
4 /33 EN
Never dispose the product
Refrigerator / User Manual