Installation; Appropriate Installation Location; Electrical Connection - Fulgor Milano F6FBM36S1 Instrucciones Para El Uso

3

Installation

Refer to the nearest Authorized Service Agent for
installation of the product. To make the product
ready for use, make sure that the electricity
installation is appropriate before calling the
Authorized Service Agent. If not, call a qualified
electrician to have any necessary arrangements
carried out.
C
Preparation of the location and electrical
installation at the place of installation is
under customer's responsibility.
B
Product must not be plugged in during
installation. Otherwise, there is the risk of
death or serious injury!
WARNING:
B
connections of the product must be carried
out by the Authorized Service Agent.
Manufacturer shall not be held liable for
damages that may arise from procedures
carried out by unauthorized persons.
A
WARNING:
check if the product has any defects on
it. If so, do not have it installed. Damaged
products cause risks for your safety.
C
Make sure that the power cord is not
pinched or crushed while pushing the
product into its place after installation or
cleaning procedures.

3.1 Appropriate installation location

WARNING:
A
the product will be placed is too small for
the product to pass, then the product's
doors must be removed and the product
must be turned aside to pass it through.
Install the product where it will not be exposed
to temperatures below freezing or exposed to
outdoor weather conditions.
Do place the product near a grounded
electrical outlet.
Do not place the product on materials such as
rugs or carpets.
Place the product on an even floor surface to
prevent jolts.
Installation and electrical
Prior to installation, visually
If the door of the room where

3.2 Electrical connection

Connect the product to a grounded outlet
protected by a fuse complying with the values in
the rating plate. Our company shall not be liable
for any damages that will arise when the product
is used without grounding in accordance with the
local regulations.
regulations.
installation.
protection are specified in the Rating Plate
which is affixed to interior of the product. If
the current value of the fuse or breaker in the
house does not comply with the value in the
rating plate, have a qualified electrician install a
suitable fuse.
mains voltage.
multi-plugs.
B
WARNING:
be replaced by the Authorized Service
Agents.
B
WARNING:
should not be operated unless it is repaired
by the Authorized Service Agent! There is
the risk of electric shock!
7 / 33 EN
Damaged power cord must
If the product has a failure, it
Refrigerator / User Manual