Install Blower In Hood - Thermador PH Professional Serie Manual De Instalación

Install Blower in Hood

1. The blower is attached to the hood using weld studs
provided on the mounting plate.
2. Figure 15 shows the weld studs in location B for
horizontal (rear) discharge. Attach four (4) #10-24 nuts
to the weld studs. For vertical discharge, attach nuts to
studs at the top of the mounting plate.
3. Guide the motor mounting plate over the studs and
tighten nuts to secure the blower to the hood.
English 10
Figure 15: Weld Stud Locations
4. Attach two (2) additional screws as shown in Figure 16.
Ventillator
Assembly
Additional
Screws
Figure 16: Attachment of Additional Screws
CAUTION:
Verify that the two (2) additional screws in
Figure 16 are installed and properly tightened
before continuing.