Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2) DESCRIPTION
2.1) General description
The
Origo Feed
TM
cored and aluminium in services of average and heavy production.
They have a progressive wire mechanism of 4 feed rollers engaged and an electronic control system. They
can be installed on the power source, hanged on the workplace with appropriate hangers or on a wheel kit to
move it around the workplace (optional). According to the model it has several functions, please see the
technical characteristics.
3) TECHNICAL CHARACTERISTICS
TABLE 3.1
Wire feeder
Power supply (V - Hz)
Wire feed speed (m/min)
Wire diameter (mm)
Solid steel
Cored wire
Aluminium
Welding gun connection
Digital Voltmeter/amperimeter
2/4 Stroke
Welding source voltage setting
Manual feeding of the wire
Double setting
Remote control
Bobbin cover
Burnback (sec.)
Dimensions (W x L x H) (mm)
Weight (kg)
4) CONTROLS
P2/P3
4.1) Front panel
1) Knob for setting wire feed speed.
2) Knob for setting the voltage.
3) Digital voltmeter/ amperimeter. To display the parameters of welding, voltage and current. After the
welding it maintains the set values shown on the display (optional in P2).
4) Connection for welding gun.
4.2) Side console
5) Burnback - Burnback time is a delay between the time when the wire starts to brake until the time when
the power source switches off the welding voltage.Too short burnback time results in a long wire stickout
after completion of welding, with a risk of the wire being caught in the solidifying weld pool. Too long a
burnback time results in a shorter stickout, with increased risk of the arc striking back to the contact tip.
24
304 wire feeders are designed for semi-automatic MIG/MAG welding with solid wires,
304 P2
304 P3
42 - 50/60
1.5 - 25.0
0.6 - 1.6
0.9 - 3.2
0.8 - 1.6
Euro-conector
Optional
Optional
No
No
Optional
0 - 0.5
270 x 550 x 340 (without bobbin cover)
270 x 660 x 415 (with bobbin cover)
17
304 P4
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
No
Yes
17.3
18
Publicidad
Tabla de contenido
